Following is the config for my router connecting to the Internet. But I am unable to connect to either the dns or the Internet. Kindl...
Following is the config for my router connecting to the Internet. But I am unable to connect to either the dns or the Internet. Kindl...
Hi I've been trying to work this one out for a while with no success. This setup is in a 2-story house with 2 WAN connections each at opposite ends of the house...
I go to 10.0.0.1:2033 (my router is a XyXEL, that's the url ZyXEL uses for the router config), and type in the username and password that is supposed to be the 'standard' one for my router ...
Hi folks, WEB--DSL Router--DI524- PC's I have a DI524 W-AP connected to a DSL Router on my LAN using DHCP. I also enabled DHCP on the W-AP. Now I can't connect to the Router via WEBconfig(192.168 ...
Create a new discussion. If you're asking for technical help, please be sure to include all your system info, including operating system, model number, and any other specifics related to the problem.
What are you looking for? GO. IT Policy Downloads 5G Developer
You have a good configuration down so far, but you are missing a few things. 1) The default gateways on your DHCP scope should be the IP Addresses of the VLAN they belong to, so below is how it ...
Hello All I have been testing this for a while, I have a few questions. I have a hp Switch 2**0 I have split this up into 4 Vlans. I ...
ip nat inside source static udp 192.168.0.200 3389 interface ... do you need an Ip address on the VLAN interface? ... please read our TechRepublic Forums FAQ.
Now, the problem is that the Dlink is not a modem so I need to connect the Dlink to my SMC and then proceed. ... Connect the wireless router WAN port to any computer and go to the login page thing.
Ok here goes.... I have a router1 in my adjacent building that connects to the internet(via uplink) from a particular service provider....
Dlink router to router for internet connection. ... you assign the WAN port with an address on the router B network. such as 192.168.1.2 255.255.255.0 subnet mask. the default gateway is router B ...
I have BT Voyager 190 modem router that I would like to connect to another wireless router (TPLINK 641G). I'll call BT Voyager as router ...
I had tried to change the LAN IP to 192.168.200.1 in SPA2102, so it is not the same with my di524. and also change the spa2102 in bridge mode. i had tried most setting still no luck to get the ...
Router Configuration 101: Setting up the router. by Christopher Albrecht in Networking on March 3, 2005, 12:00 AM PST Whether it's been years since you've worked with routers or you're just ...
I have a DLink dsl - 504 router with built in ADSL modem and I now have a DLink-DIR-655 wireless router. I need to plug the DIR - 655 ...
On my LAN my systems runs on Win 98 i have given IP address 192.168.1.12 , Gateway as 192.168.1.2 ( Which is a gateway server) & i have ...
Create a new discussion. If you're asking for technical help, please be sure to include all your system info, including operating system, model number, and any other specifics related to the problem.
Dear all, I have a cisco 2511 router with 2 serial and 1 ethernet interface.we are planning to implement two isps on the same router. Can you tell me how i can do this ,is it possible in this Router.
if you have not already done so! you can enter the configuration of netgear router, by typing http:192.168.0.1 in your web browser ( some times 192.168.02 check doc's) you'll have to log in there ...